Things You\’ll Need
-
Four pine boards, 1/2-inch thick, three inches wide, 18 inches long
-
Band saw
-
Sandpaper, medium-grain
-
Sandpaper, fine-grain
-
Washcloth
-
Staple gun
-
Staples, 1/2-inch long
-
Waterproof latex paint
-
Paintbrush
-
Staples, 1/8-inch long
Frame hardboard art using basic craft materials.
Decorative artwork and photographs are typically slid right into standard picture frames purchased from a department store. However, it is difficult to find a frame deep enough to fit a painting created on hardboard, which is thicker than a photograph or piece of paper-based artwork. Frame the hardboard painting yourself by using a few basic materials that can be found at any hardware store. This enables you to hang up a beautiful piece of art painted on hardboard without spending a fortune on custom framing.
Video of the Day
Step 1
Cut four three-inch wide, 18-inch long pine boards using a band saw to the measurement of the outside edge of the hardboard canvas, adding on three inches on each end. Cut the ends with the band saw at a 45-degree angle.
Step 2
Sand all four boards using medium-grain sandpaper. This will remove any splintering, roughness and unevenness.
Step 3
Sand all four boards again using fine-grain sandpaper. This will make the boards smooth and sleek.
Step 4
Wipe off the boards with a washcloth to remove any sawdust.
Step 5
Place the boards into a rectangle with the right sides facing down. Line up the corners so that they are flush.
Step 6
Staple across each corner using a staple gun and 1/2-inch long staples.
Step 7
Paint the frame using latex paint, any color. Allow the paint to dry for 30 minutes or until it is completely dry.
Step 8
Place the hardboard canvas into the opening of the canvas facing downward, then staple around the edges using a staple gun and small 1/8-inch wide staples.
Tip
Paint the frame to match the painting on the hardboard.
Warning
Keep staple guns out of the reach of children.
